Analyze the stamping process of metal stamping parts

Metal stamping production process:

In a multi-station progressive continuous stamping die, the workpiece is stamped out, and the process flow such as calendering and welding is carried out. However, it still has a small part connected with the stamping sheet. The stamped and welded workpiece is carried by the stamping die sheet into the ultrasonic surface treatment equipment to clean up the anti-rust grease and impurities.

The elimination of welded beans and burrs should be carried out in the shot blasting room. This is necessary to prevent short-circuit failures and short-circuiting of electrical equipment in the application of metal stamping parts. In the short-time ultrasonic metal surface treatment, before the quality inspection of the metal stamping parts, the ultrasonic surface layer removal technology is used to eliminate the residual impurities remaining during the shot peening process.

After all the above operations are completed, the metal stamping parts are completely separated from the blank sheet and stored separately. Metal stamping parts of poor quality are placed in the waste bin, and metal stamping parts that meet the standards are sent to the packaging production workshop.

This is the introduction about the stamping process of metal stamping parts, I hope it will be helpful to you!